Assign a proxy to a profile
Give any profile its own proxy — a built-in residential IP or your own HTTP/SOCKS5 proxy — so it looks like a distinct device.
Every Sendwin profile can carry its own proxy so its traffic exits from a separate IP address. This pairs with the Stealth Engine's fingerprint spoofing to make each profile look like a distinct real device in a distinct location.
The rule is simple: one proxy per profile. You can use Sendwin's built-in residential pool or bring your own HTTP or SOCKS5 proxy.
Set a proxy on a profile
- 1Open the profile's settings and go to its proxy or connection section.
- 2Choose a proxy source: the built-in residential pool, or bring your own by entering the host, port and (if needed) username and password.
- 3Pick the proxy protocol when supplying your own — HTTP or SOCKS5.
- 4Run the built-in tester to confirm the real exit IP, country and latency before you launch.
- 5Save, then launch the profile.
Tip
Creating many profiles at once? Use Bulk create to paste a proxy list plus a naming template and pair each new profile 1:1 with a proxy automatically.
Good to know
- The proxy is stored with the profile, so it travels with the profile when you Run-in-cloud — the cloud session keeps the same fingerprint and proxy.
- Change a profile's proxy any time; just re-test and relaunch.
- Built-in residential usage counts against your plan's proxy GB allowance.
Still need a hand?
Email our team and a real person will get back to you, usually within a few hours.
[email protected]